Mystery Revealed!

Small tracks limit the speeds, and forces players to carefully consider their mine dropping lest the kill themselves.

 Pay close attention to the intersection pieces.  They were designed to be used both to cap off one end of the oval track, and to create shallow S-curves for highway battles.  That means that these tiles provide 6-feet of straight highway before you have to re-use tiles.

The edges should join a little smoother on a flat table.

As of these pictures, the tiles have been primed gray for the road and tan for the off-road.  A little sand sprinkled all over gives different textures for the road and off-road.  Fine grained sand keeps the road from being ice-rink smooth, and a mix of fine and coarse sand helps delineate the off-rad areas.

These roads should wind up four lane roads – two in each direction.  The challenge here is keeping each lane a consistent width.  In the last set of photos, you can just make out the guide marks on the edges of each board.  The solid lines delineate a 1″ wide sandy shoulder, with each lane 1″ wide, and a 1/4″-edge to the asphalt.  All told, that gives us 4.5″ of safe surface, 1″ of shoulder hazard, and the rest of the board the far more dangerous off-road.  That’s a total of 6.5-inches of playable surface for each stretch of highway, even if a couple of those should only be used in emergencies.

Normally, you wouldn’t want to cut your playable surface in half like that, but for running road battles it works just fine.  It also give me room to plunk down some interesting terrain like billboards, trees, rocks, and Road-Runner-esque stone columns.  From a practical standpoint, those can block line of site in the arena.  Outside of the arena, they’ll give the boards more variety and keep it from looking like the same six feet of road.